For various purpose,the Measurment of River Discharge is required.It requires lot of Skill and the Accuracy.To Measure the Discharge of River,we require

01)Area of Flow

02)Average Velocty of Flow.

With this Data we can Calculate

Discharge=Area of Flow X Average Velocity of Flow.

To Calculate Area of Flow,we can use following Methods

A)Simple Segment Method:-
In this Method,the whole Width of River is divided into a number of Segment at Length,say L1,L2,L3 (Length of Segments) and at Depth say d1,d2,d3 (mean Depth of Segment).Now,the Area of Flow is Sum of all Area of Segments.(L1d1+L2d2+L3d3………………)

B)Simpson’s Rule:-
In this Method,the whole Width of River is divided into an even number of equal Segments,so that there are odd number of Depths taken at the end of each
Segment.

02)Average Velocity of Flow:-

To Measure Average Velocity of Flow following are three important Methods we can use.
A)Floats
B)Pitot Tube
C)Current Meter

Out of that Pitot Tube is already covered in earlier post.In this post I will cover Details about Floats and in next post,you will come to know about Current Meter.

A)Floats:-

With the help of Singal Float,the Surface Velocity,at any section of River can be eaisly obtained.For this we have to count time taken by the Float to Travel known Distance.The Velocity is Calculate by dividing the distance travelled by the Float by the time taken to travel that distance.

This Surface Velocity is then converted into an Average Velocity.To obtain Average Velocity directly,a Double Float or Rod Float is used.

01)Double Float:-

It consist of two Floats connected by a Wire or String.One Float is a Small Wooden Float,which Floats on Surface of River .Another is a Hallow Metallics Sphere which is heavier than Water is suspended from the former by a Wire or String,connecting the two Floats,in such that,the Lower Mettalic Float is at Depth of 6/10 of the Total Depth of Flow,as the Average Velocity of Flow exists at a Depth of 6/10 to the Total Depth.

The Velocity of Flow then Calculate by Dividing the distance travelled by the Float by the time taken to travel that distance.This Method Directly gives the Value of Average Velocity.

02)Rod Float:-
It consist of a Wooden Rod or a Metallic Rod Weighted at the bottom,so as to keep it Vertical or Inclined while travelling.

The Lenght of the Rod is so adjusted that it should not touch the Weeds at bottom of the River and its top should be above the Water Surface.A Telescope Rod may be used to suit different Depths.A section free from Weeds must be chosen to avoid posibilities of the Weeds at the bottom of River to Interface
with Rod Float.

For more,please visit
http://mechanicalguru.blogspot.com/

Last 5 posts by prasannas

• Avoid Breakdown of Air Compressor due to Low Water Flow. - August 26th, 2008
• How to safeguard Air Compressor from Excessive Vibrations. - August 26th, 2008
• High Discharge Air Temperature Switch used for safty of Air Compressor. - August 26th, 2008
• High Discharge Air Temperature Switch used for safty of Air Compressor. - August 26th, 2008
• Pre-Commissioning checks of Electrical Motor used to run Air Compressor. - August 20th, 2008